The following table describes the related labels in this screen.
Table 49 Multicast: Setting: MVR
LABEL | DESCRIPTION |
|
|
Active | Select this check box to enable MVR to allow one single multicast VLAN to be |
| shared among different subscriber VLANs on the network. |
Name | Enter a descriptive name (up to 32 printable ASCII characters) for identification |
| purposes. |
Multicast VLAN | Enter the VLAN ID (1 to 4094) of the multicast VLAN. |
ID |
|
Mode | Specify the MVR mode on the switch. Choices are Dynamic and Compatible. |
| Select Dynamic to send IGMP reports to all MVR source ports in the multicast |
| VLAN. |
| Select Compatible to set the switch not to send IGMP reports. |
|
|
Port | This field displays the port number on the switch. |
|
|
Source Port | This field is applicable for Ethernet ports. |
| Select this option to set this port as the MVR source port that sends and receives |
| multicast traffic. |
Receiver Port | Select this option to set this port as a receiver port that only receives multicast |
| traffic. |
None | Select this option to set the port not to participate in MVR. No MVR multicast traffic |
| is sent or received on this port. |
Tagging | Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames |
| transmitted. |
Add | Click Add to save the settings. |
|
|
Cancel | Click Cancel to discard all changes. |
|
|
VLAN | This field displays the multicast VLAN ID. |
|
|
Active | This field displays whether the multicast group is enabled or not. |
|
|
Name | This field displays the descriptive name for this setting. |
|
|
Mode | This field displays the MVR mode. |
|
|
Source Port | This field displays the source port number(s). |
|
|
Receiver Port | This field displays the receiver port number(s). |
|
|
Delete | To delete the group(s) and all the accompanying rules, select the group(s) that you |
| want to remove in the Delete column, then click the Delete button. |
Cancel | Click Cancel to clear the Delete check boxes. |
|
|
22.5 MVR Group Configuration
All source ports and receiver ports belonging to a multicast group can receive multicast data sent to this multicast group.
Configure MVR IP multicast group address(es) in the Group Configuration screen. Click Group Configuration in the MVR screen.
151 | Chapter 22 Multicast |