This command turns on GVRP in order to propagate VLAN information beyond the switch.
42.4.5 Disable GVRP
Syntax:
no vlan1q gvrp
This command turns off GVRP so that the switch does not propagate VLAN information to other switches.
42.5 Port VLAN Commands
You must configure the switch port VLAN settings in
42.5.1 Set Port VID
Syntax:
pvid <VID>
where
<VID> = Specifies the VLAN number between 1 and 4094 This command sets the default VLAN ID on the port(s).
The following example sets the default VID to 200 on ports 1 to 5.
Figure 198 vlan1q port default vid Command Example
ras (config)# interface
42.5.2 Set Acceptable Frame Type
Syntax:
where
<alltagged> = Specifies all Ethernet frames (tagged and untagged) or only tagged Ethernet frames.
Chapter 42 IEEE 802.1Q Tagged VLAN Commands | 292 |