Chapter 12 Remote Management Screens
12.2 Configuring Telnet
You can configure your ZyXEL Device for remote Telnet access as shown next. The administrator uses Telnet from a computer on a remote network to access the ZyXEL Device.
Figure 85 Telnet Configuration on a TCP/IP Network
Click REMOTE MGNT tab to display the TELNET screen as shown.
Figure 86 Remote Management: Telnet
The following table describes the labels in this screen.
Table 48 Remote Management: Telnet
LABEL | DESCRIPTION |
TELNET |
|
|
|
Server Port | You can change the server port number for a service if needed, however you must |
| use the same port number in order to use that service for remote management. |
|
|
Server | Select the interface(s) through which a computer may access the ZyXEL Device |
Access | using Telnet. |
|
|
Secured | A secured client is a “trusted” computer that is allowed to communicate with the |
Client IP | ZyXEL Device using this service. |
Address | Select All to allow any computer to access the ZyXEL Device using this service. |
| |
| Choose Selected to just allow the computer with the IP address that you specify to |
| access the ZyXEL Device using this service. |
|
|
SSH |
|
|
|
142 |
| |
ZyXEL |
| |
|
|
|