ZyXEL Communications NWA-3160 Series 12.6.1 Configuring SNMP

Chapter 12 Remote Management Screens

12.6.1 Configuring SNMP

To change your ZyXEL Device’s SNMP settings, click REMOTE MGMT, then the SNMP tab. The screen appears as shown.

Figure 90 Remote Management: SNMP

The following table describes the labels in this screen.

Table 53 Remote Management: SNMP

LABEL	DESCRIPTION
SNMP Configuration

Get Community	Enter the Get Community, which is the password for the incoming Get and
	GetNext requests from the management station. The default is public and
	allows all requests.

Set Community	Enter the Set community, which is the password for incoming Set requests
	from the management station. The default is public and allows all requests.

Community	Type the trap community, which is the password sent with each trap to the
	SNMP manager. The default is public and allows all requests.

Destination	Type the IP address of the station to send your SNMP traps to.

SNMP

Service Port	You may change the server port number for a service if needed, however you
	must use the same port number in order to use that service for remote
	management.

Service Access	Select the interface(s) through which a computer may access the ZyXEL Device
	using this service.

Secured Client IP	A secured client is a “trusted” computer that is allowed to communicate with the
Address	ZyXEL Device using this service.
	Select All to allow any computer to access the ZyXEL Device using this service.
	Choose Selected to just allow the computer with the IP address that you specify
	to access the ZyXEL Device using this service.