Ryobi RY 43160A manuel dutilisation Connecting the Poles, Lower Collar Handle Pole Button

ASSEMBLY

LOWER

COLLAR

HANDLE

POLE

BUTTON

THREADED BASE
BUTTON	INTERMEDIATE	THREADED
	POLE	BASE
CORD

UPPERPOWERHEAD

COLLARPOLE

Fig. 3

CONNECTING THE POLES

See Figure 3.

Before using the pole saw, a one-time assembly is required. When removed from the box, the three poles are connected by an electrical cord as shown above.

nRemove the four (4) rubber cord protectors from inside the poles. This material protects the cord during shipping and MUST be discarded immediately.

nUnscrew the lower collar from the threaded base on the intermediate pole and push back over the cord to the handle pole shaft as shown.

nInsert the handle pole into the intermediate pole and slide together until you hear the button click. The tubes are egg-shaped and will only install one way.

nLower the collar on the handle pole to the threaded base on the intermediate pole and rotate clockwise to secure.

nRepeat this process to attach the intermediate pole to the powerhead pole.

NOTE: Once assembled correctly, handle pole and powerhead pole should not be able to separate from intermediate pole when pulled. Repeat above steps if poles can be separated from intermediate pole.

WARNING:

Failure to lock powerhead pole as directed above could result in serious injury or death.

Page 11 — English