Ryobi RY 43160A manuel dutilisation Troubleshooting, Storing the Product, Problem Cause Remedy

MAINTENANCE

STORING THE PRODUCT

See Figure 23.

Clean all foreign material from the product. Store idle unit indoors in a dry, well-ventilated area that is inaccessible to children. Keep away from corrosive agents such as garden chemicals and de-icing salts.

n Always place the scabbard on the saw bar when transporting or storing the pole saw. The scabbard is a snug fit and must be attached very carefully due to the sharp teeth on the saw chain. This is best done by grasping the scabbard at one end, in the center portion of the scabbard, and carefully sliding it over the chain as shown. Use caution to avoid the sharp teeth of the chain.

SCABBARD

Fig. 23

NOTE: The saw chain is very sharp. Always wear protective gloves when handling the chain.

TROUBLESHOOTING

PROBLEM	CAUSE	REMEDY
Bar and chain	Check chain tension	Tension chain. Refer to Chain Tension earlier in this
running hot and	for overtightened	manual.
smoking.	condition
	Bar lube reservoir	Check bar lube reservoir.
	empty
Motor runs,	Chain tension too	Retention chain. Refer to Chain Tension earlier in this
but chain is not	tight.	manual.
rotating.	Check guide bar and	Refer to Replacing the Bar and Chain earlier in this
	chain assembly.	manual.
	Check guide bar and	Inspect guide bar and chain for damage.
	chain for damage.

CALL US FIRST

For any questions about operating or maintaining your product,

call the Ryobi® Help Line!

Your product has been fully tested prior to shipment to ensure

your complete satisfaction.

Page 20 — English