Electrical and Fuel Inlet Locations
The 3/4 inch N.P.T. fuel inlet connector (A) and electrical inlet location (B) are shown below.
The home generator is shipped already attached to its mounting pad. Unless mandated by local code, a concrete slab is not required.
B
Lifting the Generator
WARNING Hazardous Voltage - Contact with power
lines could cause electric shock or burns,
resulting in death or serious injury.
Lifting Hazard / Heavy Object - Could result in serious injury.
t If lifting or hoisting equipment is used, DO NOT contact any power lines.
t DO NOT lift or move generator without assistance.
t Use lifting pipes as described in Lifting the Generator.
t DO NOT lift unit by roof as damage to generator will occur.
The generator has a shipping weight of approximately 605 pounds (274 kg). Proper tools, equipment and qualified personnel should be used in all phases of handling and moving the generator.
5XPwMFOHUITPGwQJQF C), supplied by the installer, are required to lift the generator manually. Insert pipes through the lifting holes (D) located near the unit’s base.
A |
| :PVNBZBMTPMJGUUIFVOJUVTJOHBiIPPLBOEIPJTUwNFUIPE | ||
| UTION | that you use a spreader | ||
|
| attached to the lifting pipes, provid | ||
|
| bar to ensure that the chains or cables DO NOT touch the | ||
|
| generator’s roof. |
| |
|
| After unit is in place, fill the lifting holes with the supplied | ||
|
| lifting hole plugs. |
| |
| REPROD | C |
| |
|
|
| ||
| NOT |
|
|
|
| FOR |
|
|
|
|
|
|
| D |
|
|
|
| C |
17