Homelite UT80715 Connecting the Water Supply to the Pressure Washer, Assembling the Spray Wand

Page 10

ASSEMBLY

WARNING:

Do not attempt to modify this product or create acces- sories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.

WARNING:

Do not connect to power supply until assembly is com- plete. Failure to comply could result in accidental starting and possible serious personal injury.

CONNECTING THE WATER SUPPLY TO THE PRESSURE WASHER

See Figure 3.

CAUTION:

Always observe all local regulations when connnecting hoses to the water main. Some areas have restrictions against connecting directly to public drinking water sup- ply to prevent the feedback of chemicals into the drinking water supply. Direct connection through a receiver tank or backflow preventer is usually permitted.

The water supply must come from a water main. NEVER use hot water or water from pools, lakes, etc.

Before connecting the garden hose to the pressure washer:

nRun water through the hose for 30 seconds to clean any debris from the hose.

nInspect the screen in the water intake.

nIf the screen is damaged, do not use the machine until the screen has been replaced.

nIf the screen is dirty, clean it before connecting the garden hose to the machine.

To connect the garden hose to the machine:

nStraighten the garden hose.

NOTE: There must be a minimum of 10 feet of unrestricted hose between the pressure washer intake and the hose faucet or shut off valve (such as a “Y” shut off connector).

nWith the hose faucet turned completely off, attach the garden hose to the pump inlet coupler. Tighten by hand.

CONNECTING THE HIGH PRESSURE HOSE TO THE PUMP

See Figure 4.

nInsert the nipple on the end of the high pressure hose collar into the pump outlet.

nSlide the collar over the outlet turning the collar clockwise to tighten securely.

nPull on the hose to be certain it is properly secured.

CAUTION:

Do not run the pressure washer pump without water sup- ply connected and turned on, as this may damage the high pressure seals and decrease pump life. Completely unwind the hose from its reel or coil and make sure the hose is not being restricted by tires, rocks, or any other objects that may lessen or prevent water flow to the pressure washer.

ASSEMBLING THE SPRAY WAND

See Figure 5.

nInsert the end of the spray wand into the trigger handle outlet coupler.

nTurn the connector clockwise until it stops. This secures the wand in place.

USING THE SPRAY WAND AS A HANDLE

See Figure 6.

When not in use, the spray wand can be stored in the cleaning deck. In this position, the wand is then used as a handle to push/move the pressure washer from place to place.

Attaching the spray wand to the cleaning deck:

nAssemble the trigger handle and spray wand as described previously in this manual.

nInsert spray wand quick connect coupler into the clean- ing deck inlet plug. Tilt upward until coupler clips into position.

WARNING:

To reduce the risk of injection or injury, only use the cleaning deck on flat, horizontal surfaces. Never lift the cleaning deck from the cleaning surface while operating the pressure washer.

CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANDLE

See Figures 7 - 8.

nInsert the nipple on the end of the high pressure hose collar into the handle inlet coupler.

nSlide the collar over the coupler, turning the collar clock- wise to tighten securely.

nPull on the hose to be certain it is properly secured.

nAttach the hook-and-loop strap to the trigger handle and high pressure hose.

NOTE: Use the hook-and-loop strap to secure the electri- cal cord and garden hose during operation.

8 — English

Page 9 Page 11
Image 10
Page 9 Page 11
Contents OPERATOR’S Manual Save this Manual for Future ReferenceGancho y lazada Iii Table of Contents IntroductionGround Fault Circuit Interrupter Protection Important Safety InstructionsRead ALL Instructions Before Using this Product Servicing of a DOUBLE-INSULATED ApplianceSpecific Safety Rules Symbols Symbol Signal MeaningDouble Insulation Ground Fault Circuit InterrupterElectrical Electrical ConnectionFeatures AssemblyUsing the Spray Wand AS a Handle Connecting the Water Supply to the Pressure WasherConnecting the High Pressure Hose to the Pump Connecting High Pressure Hose to Trigger HandleApplications Using the Spray Wand TriggerOperation Adding Detergent to the Pressure WasherUsing the Cleaning Deck Using the NozzlesUsing the High Pressure Hose Operating the Pressure WasherNozzle Maintenance MaintenanceGeneral Maintenance Moving the Pressure WASHER­Changing the High Pressure Filter Cleaning the Deck NozzlesTo clean nozzles Storing the Pressure WasherTroubleshooting Problem Possible Cause SolutionWarranty Limited Warranty StatementInstructions Importantes Concernant LA Sécurité Conserver CES InstructionsRègles DE Sécurité Particulières Symboles Symbole Signal SignificationDisjoncteur DE Fuite À LA Terre Caractéristiques ÉlectriquesIsolation Double Connexion ÉlectriqueCaractéristiques AssemblageUtilisation DE LA Lance D’ARROSAGE Comme Poignée Connexion DU Tuyau Haute Pression SUR LA PompeAssemblage DE LA Lance DE Pulvérisation Connexion DU Tuyau Haute Pression À Poignée DE GâchetteMise EN Marche / Arrêt DU Nettoyeur Haute Pression UtilisationAjout DE Détergent Dans LA Laveuse À Pression Fonctionnement Poignée DE GâchetteUtilisation LA Nettoyeur Haute Pression Fonctionnement LES BusesUtilisation DU Tuyau Haute Pression Pour engager le verrouillage Utiliser DE Pont DE Nettoyer Déplacement DU Nettoyeur Haute PressionEntretien Entretien GénéralChangement DU Filtre Haute Pression Entretien DE BusePour Nettoyer LE Buse À Pont Remisage DU Nettoyeur Haute PressionProblème Cause Possible Solution DépannageGarantie Énoncé DE LA Garantie Limitée Hors MoteurAdvertencia Instrucciones DE Seguridad ImportantesGuarde Estas Instrucciones LEA Todas LAS Instrucciones Antes DE Usar Este ProductoReglas DE Seguridad Específicas Peligro SímbolosPrecaución Conexión Eléctrica Aspectos EléctricosDoble Aislamiento Vea la figuraCaracterísticas ArmadoArmado DEL Tubo Rociador Cómo Conectar LA Manguera DE Alta Presión a LA BombaUtilizar DEL Tubo Rociador Como LA Mango Usos FuncionamientoEncendido Y Apagado DE LA Lavadora DE Presión Agregado DE Detergente a LA Lavadora DE PresiónUSO DE LA Manguera DE Alta Presión USO LAS BoquillasAccionamiento DE LA Lavadora DE Presión Cómo Mover LA Lavadora a Presión MantenimientoUSO DE LA Unidad DE Limpieza Mantenimiento GeneralLimpieza DEL Filtro DE Alta Presión Mantenimiento DE LAS BoquillasMantenimiento DE LAS Boquillas DE LA Unidad Guardado DE LA Lavadora DE PresiónSolución DE Problemas Problema Causa Posible SoluciónGarantía Declaración DE Garantía Limitada CON Excepción DEL MotorPage Manuel D’UTILISATION Manual DEL Operador OPERATOR’S ManualAVERTISSEMENT 
Top Page Image Contents