Murray 11052x4NC Outside of the lower handle as you, Tighten the knobs, Lower handles see Figure

ASSEMBLY

3.	Insert the right lower handle into the
	mounting channel (see Figure 3). Make
	sure the flat end at the top of the handle
	is facing inward.
4.	Mount a washer on each screw. Push
	the screws through the tine shield, the
	lower handle, and half way through the
	engine casting (see Figure 4).
5.	Insert the left lower handle into the
	mounting channel (see Figure 3). Make
	sure the flat end at the top of the handle
	is facing inward.
6.	Push the screws through the engine
	casting, the lower handle, and the tine
	shield. Secure with washers and lock-
	nuts as shown in Figure 4. Do not tight-
	en as this time.

Left Lower

Handle

Right Lower

Handle

Mounting Channel Figure 3

7.	Remove the fasteners from the upper
	handle (see Figure 5).
8.	Assemble the upper handle to the lower
	handles with the fasteners.
9.	Tighten the knobs.
	NOTE: To tighten the knobs, hold the

Washer

Washer

Screw

Locknut

curved carriage bolt head against the

outside of the lower handle as you

tighten the knobs.

10. Tighten the locknuts that hold the ends

of the lower handles (see Figure 4).

Tighten only enough to firmly hold the

handles.

CAUTION: Over tightening the lock-

nuts can change the shape of the han-

dle and damage the engine casing.

Tine Shield

Figure 4

CurvedFlat Washer Knob

Washer

Carriage	Upper Handle
Bolt

Figure 5

F–041306C 8