Intel Itanium 2 Processor manual Alphabetical Signals Reference

A Signals Reference

	This appendix provides an alphabetical listing of all Itanium 2 processor system bus signals. The
	tables at the end of this appendix summarize the signals by direction: output, input, and I/O.
	For a complete pinout listing including processor specific pins, please refer to Chapter 3, “Pinout
	Specifications.”
A.1	Alphabetical Signals Reference
A.1.1	A[49:3]# (I/O)
	The Address (A[49:3]#) signals, with byte enables, define a 250 Byte physical memory address
	space. When ADS# is active, these pins transmit the address of a transaction. These pins are also
	used to transmit other transaction related information such as transaction identifiers and external
	functions in the cycle following ADS# assertion. These signals must connect the appropriate pins
	of all agents on the Itanium 2 processor system bus. The A[49:27]# signals are parity-protected by
	the AP1# parity signal, and the A[26:3]# signals are parity-protected by the AP0# parity signal.
	On the active-to-inactive transition of RESET#, the processors sample the A[49:3]# pins to
	determine their power-on configuration.
A.1.2	A20M# (I)
	A20M# is ignored in the Itanium 2 processor system environment.
A.1.3	ADS# (I/O)
	The Address Strobe (ADS#) signal is asserted to indicate the validity of the transaction address on
	the A[49:3]#, REQ[5:0]#, AP[1:0]# and RP#pins. All bus agents observe the ADS# activation to
	begin parity checking, protocol checking, address decode, internal snoop, or deferred reply ID
	match operations associated with the new transaction.
A.1.4	AP[1:0]# (I/O)
	The Address Parity (AP[1:0]#) signals can be driven by the request initiator along with ADS# and
	A[49:3]#. AP[1]# covers A[49:27]#, and AP[0]# covers A[26:3]#. A correct parity signal is high if
	an even number of covered signals are low and low if an odd number of covered signals are low.
	This allows parity to be high when all the covered signals are high.
A.1.5	ASZ[1:0]# (I/O)
	The ASZ[1:0]# signals are the memory address-space size signals. They are driven by the request

initiator during the first Request Phase clock on the REQa[4:3]# pins. The ASZ[1:0]# signals are valid only when REQa[2:1]# signals equal 01B, 10B, or 11B, indicating a memory access transaction. The ASZ[1:0]# decode is defined in Table A-1.

Datasheet 91