Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 | Revision A |
Table 3-5. Check point for Paper out error according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point
Remedy
•Operation
•–
The drive of the PF Motor is not transmitted to the LD Roller Shaft.
1. Check if the Extension Spring comes off from the Clutch | 1. Reassemble the Extension Spring in the Clutch | ||
mechanism. | mechanism. | ||
|
|
|
|
| Extension Spring |
|
|
LD Roller | 2. Check if the positioning hole of the Clutch comes off | 2. Reassemble the positioning hole of the Clutch |
from the guide pin of the LD Roller Shaft. | on the guide pin of the LD Roller Shaft. | |
Assy | Guide pin |
|
|
| |
| Clutch |
|
LD Roller Shaft
| 3. | Check if the Clutch tooth is damaged. | 3. | Replace the LD Roller Assy with a new one. |
|
|
|
|
|
| 4. | Check if the Clutch is damaged. | 4. | Replace the LD Roller Assy with a new one. |
|
|
|
|
|
| 1. | Check if the Compression Spring comes off from the | 1. | Replace the Change Lever and Compression |
|
| Change Lever. |
| Spring with new ones. |
ASF Unit
Compression Spring
Change Lever
TROUBLESHOOTING | Error Indications and Fault Occurrence Causes | 41 |