Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 | Revision A |
6.Remove the four screws that secure the Main Frame to the Lower Housing.
Front Right |
Lever Pick Clutch
Rear Left |
Screw it with the
Grounding Wire.
CAUTION | Do not damage the PF Scale and the Lever Pick Clutch with the |
| Main Frame. |
After removing the Main Frame, do not lay it with the Driven
Roller of the Upper Paper Guide facing downward.
7.Remove the Main Frame, the Carriage, and the Upper Paper Guide from the Lower Housing following the procedure below. (See
1.Lift the Main Frame until the dowel and the rib that secure the Main Frame comes off.
2.Rotate the Main Frame in the direction of the arrow and remove it not to interfere the Upper Paper Guide with the LD Roller Shaft.
Main Frame | Carriage |
|
LD Roller Shaft
Upper Paper Guide
Figure 4-75. Removing the Main Frame (5)
Rib and Groove
Hook of ASF Unit
Positioning Hole and Dowel
SCREW M3x8
SCREW
Figure 4-74. Removing the Main Frame (4)
ADJUSTMENT REQUIRED
When installing the Main Frame, align it with the following parts, and secure it with the screws. (See
•The two ribs of the frame and the two grooves of the Lower Housing
•The two positioning holes on the lower side of the frame and the two dowels of the Lower Housing
•The hook of the ASF Unit and the hole of the Main Frame above the Lever Pick Clutch
Whenever the Main Frame is removed/replaced, the required adjustments must be carried out.
•Chapter 5 “ ADJUSTMENT” (p.100)
DISASSEMBLY/ASSEMBLY | Disassembling the Printer Mechanism | 85 |