Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 | Revision A |
4.5.3 Hopper
Parts/Components need to be removed in advance:
Scanner Stand/Cover Wire (p60), Scanner Unit (p62), Middle Housing (p63) Panel Unit (p64)
Removal procedure
1.Release both the dowels that secure the Hopper, and remove the Hopper and the Compression Spring from the Lower Housing.
Lower Housing
2.Release the hook that secures the Edge Guide, and remove the Hopper from the Edge Guide.
Hopper |
Hook |
Edge Guide
Figure 4-38. Removing the Edge Guide
When installing the Hopper, make sure to install the Compression Spring under the rib as shown below.
Compression Spring
Rib |
Compression Spring | Hopper |
Hook |
Figure 4-37. Removing the Hopper
ADJUSTMENT REQUIRED
Figure 4-39. Assembling the Hopper
Whenever the Hopper is removed/replaced, the required adjustments must be carried out.
•Chapter 5 “ ADJUSTMENT” (p.100)
DISASSEMBLY/ASSEMBLY | Disassembling the Printer Mechanism | 72 |