Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 | Revision A |
Table 3-5. Check point for Paper out error according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point
Remedy
•Operation
•–
1. Check if any paper dust is adhered to the surface of the | 1. Set a cleaning sheet in the ASF Unit up side | ||
LD Roller. | down. Then holding the top edge, try to load the | ||
|
|
| paper from the Printer driver. The micro pearl |
|
|
| on the LD Roller surface is removed. To |
| LD Roller |
| |
|
| remove severe smear, staple a cloth moistened | |
|
|
| |
|
|
| with alcohol to a post card and clean the roller |
|
|
| in the same manner. |
The LD Roller cannot pick up paper | ASF Unit |
|
although the LD Roller attempt to rotate | the base sheet) | |
correctly. | ||
|
| (Use a post card for |
| CL Sheet |
|
| Adhesive Area | Staples |
|
| |
| This side down | Cloth moistened |
|
| |
|
| with alcohol |
*If the problem is not solved, replace the ASF unit with a new one.
1. Check if the Hopper operates correctly in the paper | 1. Reassemble the Compression Spring between |
loading sequence. | the Lower Housing and the Hopper. |
The Hopper does not operate during the |
| |
paper loading sequence although the LD | Hopper | |
Roller rotates to load paper from the ASF | ||
| ||
Unit. |
|
Compression Spring
Hopper
TROUBLESHOOTING | Error Indications and Fault Occurrence Causes | 40 |