Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 | Revision A |
3.2.2 Superficial Phenomenon-Based Troubleshooting
This section explains the fault locations of the error states (print quality and abnormal noise) other than the error states (LED and STM3) in the previous section.
Table
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point
Remedy
1.Check if the Extension Spring operates correctly in the paper loading sequence.
1.Set the Extension Spring between the Retard Roller Assy and the ASF Housing.
Backside of ASF Unit
•Operation
•–
The LEDs and STM3 are not indicating error conditions. But, multiple sheets of paper are always loaded from the ASF Unit.
ASF Unit
| Extension Spring |
|
|
|
|
|
|
2. Check if the Paper Back Lever operates correctly in the | 2. Set the Extension Spring between the ASF | ||
paper loading sequence. | Housing and the Paper Back Lever. |
Extension Spring
Paper Back Lever
TROUBLESHOOTING | Error Indications and Fault Occurrence Causes | 46 |