Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 | Revision A |
Table 3-5. Check point for Paper out error according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point
Remedy
•Operation
•–
The LD Roller is not set to the ASF home position and paper is always loaded from the ASF Unit during the paper loading sequence.
ASF Unit
1. Check if the tip of the Change Lever is damaged.
1. Replace the Change Lever with a new one.
Table
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point
Remedy
•Operation
•–
After both surfaces were printed, the paper was ejected but an error is displayed.
ASF Unit
1. Check if the Extension Spring operates correctly in the | 1. Set the Extension Spring between the Retard | ||
paper loading sequence. | Roller Assy and the ASF Housing. | ||
|
|
|
|
| Backside of ASF Unit |
|
|
| Extension Spring |
|
|
|
|
|
|
2. Check if the Paper Back Lever operates correctly in the | 2. Set the Extension Spring between the ASF | ||
paper loading sequence. | Housing and the Paper Back Lever. |
Extension Spring
Paper Back Lever
TROUBLESHOOTING | Error Indications and Fault Occurrence Causes | 42 |