Xerox 2045e appendix System Settings Parallel Connection

System Settings (Parallel Connection)

System Settings (Parallel Connection)

Interface Settings/Parallel Interface

❖Parallel Timing

Specifies the timing for the parallel interface. Normally, you do not need to change this setting.

•ACK inside

•ACK outside

•STB down

Note

❒ Default: ACK outside

❖Parallel Communication Speed

Specifies the communication speed of the parallel interface. If the speed is too high, data may not be transferred smoothly. If this happens, change the setting to “Standard”.

• High speed

• Standard

❖Input Prime

Specifies whether the prime signal is active or inactive when an input prime signal is sent. Normally, you do not need to change this setting.

•Effective

•Invalid

Note

❒ Default: Invalid

❖Bidirectional Communication

Specifies, for instance, how a print- er connected to the parallel inter- face responds to a status request. If you experience problems using an- other manufacturer’s printer, set

this to OFF. 6

Limitation

❒If set to OFF, asynchronous communication will not work.

•ON

Note	• OFF
❒ Default: High speed	Note

❖Selection Signal Status

Specifies the signal level of the par- allel interface.

•High

•Low

Note

❒Default: High

❒Default: ON

❖Signal Control

Specifies how to handle any errors that occur when printing from a computer or sending faxes. Nor- mally, you do not need to change this setting.

• Job acceptance priority

• Printer priority

• Facsimile priority

Note

❒Default: Job acceptance priority

65