Network
Management Card
User Manual
[2] 0.0.0.0 | public | NotAccess |
[3] 0.0.0.0 | public | NotAccess |
[4] 0.0.0.0 | public | NotAccess |
COMMANDS -
1.Modify - Modify an entry of table
2.Reset - Reset an entry to default from table
0.Return to previous menu
Please Enter Your Choice =>
This menu enables configuration of access to the four supervision stations (identified by the IP address) with read/write community names different to those already defined in the card “1” menu.
First enter the figure corresponding to the command to be carried out, then the number of the target input. The example below shows how to configure the read/write rights for a station (172.17.1.1) with a community name MyCom:
Please Enter Your Choice => 1 Entry Number : 1
Enter IP address : [0.0.0.0] 172.172.1.1
Enter Community String : [public] MyCom Select Access Type -
[NotAccess]
1.Read
2.Read/Write
3.NotAccess
Please Enter Your Choice => 2 +============================================================================+
IP Address Community String Access +============================================================================+
[1] 172.172.1.1 | MyCom | Read/Write |
6.1.4 Choice 4: Restore default configuration
Use this function to restore the card’s factory configuration. Reboot the card so that the network parameter changes are taken into account.
6.1.5 Choice 5: Reset the card
Use this function to reboot the card
Network Management Card – User Manual | 34003676EN/HA | Page 68/81 |