Maxon Telecom MM-6280IND manual Band Selection AT$$MBAND, Enter PIN +CPIN, AT$$MBAND Read Command

1.29. Band Selection (AT$$MBAND)

This command is used to read and write of the band selection.

Table 24. AT$$MBAND Read Command

Command		TE2		Æ	MT2	$$MBAND? <CR>
Response		TE2		Å	MT2	$$MBAND: [result value] <CR>
						<result_code>(OK ERROR)
	0		: auto
Result Value	1		: 850MHz
		2 : 2.1GHz
	3		: Not Setting
Table 25. AT$$MBAND Write Command
Command		TE2		Æ	MT2	$$MBAND= <Setting value> <CR>
Response		TE2		Å	MT2	$$MBAND: [result value] <CR>
						<result_code>(OK ERROR)
Setting	0		: auto
	1		: 850MHz
Value
	2		: 2.1GMHz
Result value	0		: Fail
	1		: Success

1.30. Enter PIN +CPIN

Set command sends to the MT a password which is necessary before it can be operated (SIM PIN, SIM PUK, PH-SIM, PIN, etc.). If the PIN is to be entered twice, the TA shall automatically repeat the PIN. If no PIN request is pending, no action is taken towards MT and an error message, +CME ERROR, is returned to TE.

Table 26. +CPIN parameter command syntax

Command	Possible response(s)
+CPIN=<pin>[,<newpin>]	+CME ERROR: <err>
+CPIN?	+CPIN: <code>
	+CME ERROR: <err>
+CPIN=?

HSDPA Standard At Commands Page 34 of 60 Version 1.2