Maxon Telecom MM-6280IND manual Signal strength reading, Ph-Sim Pin

Value

“READY”	MT is not pending for any password
“SIM PIN”	MT is waiting SIM PIN to be given
“SIM PUK”	MT is waiting SIM PUK to be given
“PH-SIM PIN”	MT is waiting phone-to-SIM card password
	to be given
“PH-FSIM PIN”	MT is waiting phone-to-very first SIM card
	password to be given

“PH-FSIM PUK” MT is waiting phone-to-very first SIM card

“SIM PIN2”	unblocking password to be given
	MT is waiting SIM PIN2 to be given (this
	<code> is recommended to be returned only
	when the last executed command resulted in
	PIN2 authentication failure (i.e. +CME
	ERROR: 17); if PIN2 is not entered right
	after the failure, it is recommended that MT
“SIM PUK2”	does not block its operation)
	MT is waiting SIM PUK2 to be given (this
	<code> is recommended to be returned only
	when the last executed command resulted in
	PUK2 authentication failure (i.e. +CME
	ERROR: 18); if PUK2 and new PIN2 are not
	entered right after the failure, it is
	recommended that MT does not
“PH-NET PIN”	block its operation)
	MT is waiting network personalization
	password to be given
“PH-NET PUK”	MT is waiting network personalization
	unblocking password to be given
PH-NETSUB”	PIN MT is waiting network subset
	personalization password to be given
“PH-NETSUB”	PUK MT is waiting network subset
	personalization unblocking password to
	be given
“PH-SP PIN”	MT is waiting service provider
	personalization password to be given
“PH-SP PUK”	MT is waiting service provider
	personalization unblocking password
	to be given

“PH-CORP PIN” MT is waiting corporate personalization

password to be given

“PH-CORP PUK” MT is waiting corporate personalization unblocking password to be given

1.31. Informative examples

1.31.1.Signal strength reading

Command: AT+CSQ

Expected response: +CSQ: signalstrength,BER Signalstrength possible values:

0 -113 dBm or less

HSDPA Standard At Commands Page 35 of 60 Version 1.2