Maxon Telecom MM-6280IND manual Quality of Service Profile Requested +CGEQREQ, Crlf+Cgqmin, Sdu

+CGQMIN=?	+CGQMIN: <PDP_type>, (list of supported <precedence>s), (list
	of supported <delay>s), (list of supported <reliability>s) ,
	(list of supported <peak>s), (list of supported <mean>s)
	[<CR><LF>+CGQMIN:	<PDP_type>,	(list	of	supported
	<precedence>s), (list of supported <delay>s),				(list of
	supported <reliability>s) , (list of supported <peak>s), (list
	of supported <mean>s)[…]]
Value	<cid>: a numeric parameter which specifies a particular PDP context definition (see the
	+CGDCONT and +CGDSCONT commands).
	The following parameters are defined in -3GPP TS 23.107 [46]:
	<precedence>: a numeric parameter which specifies the precedence class
	<delay>: a numeric parameter which specifies the delay class
	<reliability>: a numeric parameter which specifies the reliability class
	<peak>: a numeric parameter which specifies the peak throughput class
	<mean>: a numeric parameter which specifies the mean throughput class
	If a value is omitted for a particular class then this class is not checked

1.32.6.3G Quality of Service Profile (Requested) +CGEQREQ

This command allows the TE to specify a UMTS Quality of Service Profile that is used when the MT sends an Activate PDP Context Request message to the network.

The set command specifies a profile for the context identified by the (local) context identification parameter, <cid>. The specified profile will be stored in the MT and sent to the network only at activation or MS-initiated modification of the related context. Since this is the same parameter that is used in the +CGDCONT and +CGDSCONT commands, the +CGEQREQ command is effectively an extension to these commands. The QoS profile consists of a number of parameters, each of which may be set to a separate value.

A special form of the set command, +CGEQREQ= <cid> causes the requested profile for context number <cid> to become undefined.

The read command returns the current settings for each defined context.

The test command returns values supported as a compound value. If the MT supports several PDP types, the parameter value ranges for each PDP type are returned on a separate line..

Table 33. + CGEQREQ parameter command syntax

	Command						Possible response(s)
+CGEQREQ=[<cid> [,<Traffic					OK
class>	[,<Maximum		bitrate		ERROR
UL> [,<Maximum		bitrate		DL>
[,<Guaranteed		bitrate		UL>
[,<Guaranteed		bitrate		DL>
[,<Delivery		SDU	order>
[,<Maximum			size>
[,<SDU	error		ratio>
[,<Residual		bit	error
ratio>	[,<Delivery			of
erroneous			SDUs>
[,<Transfer			delay>
HSDPA Standard At Commands						Page 45 of 60	Version 1.2