Table 29. +CGDCONT parameter command syntax
Command |
|
| Possible response(s) | |
+CGDSCONT=[<cid> , | OK |
|
| |
<p_cid> | [,<d_comp> | ERROR |
|
|
[,<h_comp>]]] |
|
|
| |
+CGDSCONT? |
| +CGDSCONT: <cid>, <p_cid>, <d_comp>, <h_comp> | ||
|
| [<CR><LF>+CGDSCONT: <cid>, <p_cid>, <d_comp>, <h_comp> | ||
|
| [...]] |
|
|
+CGDSCONT=? |
| +CGDSCONT: | (range of supported <cid>s), (list of <cid>s for | |
|
| active primary contexts), (list of supported <d_comp>s), | ||
|
| (list of supported <h_comp>s) | ||
Value |
| <cid>: (PDP Context Identifier) a numeric parameter which specifies a particular PDP | ||
| context definition. The parameter is local to the | |||
|
| PDP | ||
|
| returned by the test form of the command. | ||
|
| <p_cid>: (Primary PDP Context Identifier) a numeric parameter which specifies a | ||
|
| particular PDP context definition which has been specified by use of the +CGDCONT | ||
|
| command. The parameter is local to the | ||
|
| returned by the test form of the command. | ||
|
| <d_comp>: a numeric parameter that controls PDP data compression (applicable for | ||
|
| SNDCPonly) (refer 3GPP TS 44.065 [61]) | ||
|
| 0 | - off | (default if value is omitted) |
|
| 1 | - on (manufacturer preferred compression) | |
|
| 2 | - V.42bis | |
|
| 3 | - V.44 | |
|
| Other values are reserved. | ||
|
| <h_comp>: a numeric parameter that controls PDP header compression (refer 3GPP TS | ||
|
| 44.065 [61] and 3GPP TS 25.323 [62]) | ||
|
| 0 | - off (default if value is omitted) | |
|
| 1 | - on (manufacturer preferred compression) | |
|
| 2 | - RFC1144 (applicable for SNDCP only) | |
|
| 3 | - RFC2507 | |
|
| 4 | - RFC3095 (applicable for PDCP only) | |
|
| Other values are reserved. | ||
|
|
|
|
|
1.32.3.Traffic Flow Template +CGTFT
This command allows the TE to specify a Packet Filter - PF for a Traffic Flow Template - TFT that is used in the GGSN for routing of
The set command specifies a Packet Filters that is to be added to the TFT stored in the MT and used for the context identified by the (local) context identification parameter, <cid>. The specified TFT will be stored in the GGSN only at activation or
HSDPA Standard At Commands | Page 40 of 60 | Version 1.2 |