parameters on the form 'f.t'.
<source port range>:Consists of
<ipsec security parameter index (spi)>: Hexadecimal parameter, value range from 00000000 to FFFFFFFF.
<type of service (tos) (ipv4) and mask / traffic class (ipv6) and mask>:
<flow label (ipv6)>: Hexadecimal parameter, value range from 00000 to FFFFF. Valid for IPv6 only.
<evaluation precedence index>: Numeric parameter, value range from 0 to 255.
Some of the above listed attributes may coexist in a Packet Filter while others mutually exclude each other, the possible combinations are shown in 3GPP TS 23.060[47].
1.32.4.Quality of Service Profile (Requested) +CGQREQ
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an Activate PDP Context Request message to the network.
The set command specifies a profile for the context identified by the (local) context identification parameter, <cid>. Since this is the same parameter that is used in the +CGDCONT and +CGDSCONT commands, the +CGQREQ command is effectively an extension to these commands. The QoS profile consists of a number of parameters, each of which may be set to a separate value.
A special form of the set command, +CGQREQ= <cid> causes the requested profile for context number <cid> to become undefined.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several PDP types, the parameter value ranges for each PDP type are returned on a separate line.
Table 31. + CGQREQ parameter command syntax
Command | Possible response(s) |
+CGQREQ=[<cid> | OK |
[,<precedence> | ERROR |
[,<delay> |
|
[,<reliability.> |
|
[,<peak> |
|
[,<mean>]]]]]] |
|
+CGQREQ? | +CGQREQ:<cid>,<precedence>,<delay>,<reliability>, |
| <peak>,<mean> |
| [<CR><LF>+CGQREQ:<cid>,<precedence>,<delay>, |
| <reliability.>,<peak>,<mean>[…]] |
HSDPA Standard At Commands | Page 43 of 60 | Version 1.2 |