GETTING STARTED
2.Press and hold the Set button, then release the Reset button.
3.Hold the Set button until the unit boots to a screen that reads “Touchpad Calibration. Please touch square with finger (1/5)”.
4.Look for a square at the top of the screen. Touch the square when it is located.
5.Repeat the previous step four more times. The unit will count each time the square is pressed correctly. It will count (1/5), (2/5), etc.
6.Once the screen has been calibrated, it will reboot to the Main Menu Screen.
Buttons
The Omniclone Xi™ features two “Shortcut” buttons that are located to the right of the touch Screen. These buttons are available at all times.
∙START/STOP Button – Press it twice to begin a cloning operation using the current settings; press the START/STOP button in mid process to abort it. A single key stroke presents a preview screen where you can see the current setting, and decide whether to press it again to begin the capture, or back out to reconfigure.
∙SET Button – Press this button once to bring you to the settings screen where you can change capture modes and other settings of the unit.
Indicator Lights
The Omniclone Xi™ has indicator lights that are located on the User Interface panel as well as on the light bar. The lights are as follows:
The POWER indicator light is a red LED located to the right of the Touch Screen. It remains on while the Logicube Omniclone Xi™ is receiving power.
The STATUS indicator lights are located to the left of the Touch Screen as a series of green LED’s. Each Master and Target drive position has a corresponding Status indicator. These lights are lit during cloning operations and any operation that accesses the Master or Target drive. They will flash as data is transferred from one drive to the other.
The GREEN light on the light bar is also a general Status indicator light. It will blink during a cloning or diagnostic operation. In addition, if the unit completes an operation successfully the green light will stay lit.
10 | Logicube Omniclone Xi ™ User’s Manual |