Logicube Omniclone Xi user manual Repair Target Mode Step-by-Step, WipeClean Target Mode

OMNIDIAGNOSTICS™

Repair Target Mode Step-by-Step

1.From anywhere in the menu system, press the Set button to enter the Settings menu.

2.Press the Cloning Mode icon that appears in the upper left-hand corner. A list of the available cloning modes appears.

3.Press the “Repair” icon, the Repair Target™ settings screen will appear.

4.You may now double-click the “Start/Stop” button to start cloning. You will be warned that continuing will modify your Destination drive. If you are ready to do this, choose “Yes” to continue.

5.When finished, the Logicube Omniclone Xi™ will notify you and display a list of the scanned drives along with bad, weak and repaired sectors found on each drive.

6.After reviewing the summary, touch the Back icon to return to the main menu.

WipeClean™ Target Mode

The WipeClean™ Target mode erases all data on the Target drives. This may be required when discarding drives that contain sensitive information to which you do not want others to have access, e.g. financial information, trade secrets, etc.

WipeClean™ writes a pattern over the whole Target drive 2 X n+1 times, where n is the selected number of iterations of all 0’s and all 1’s. The last pass then writes the chosen pattern to every byte of the drive.

For example, if you set the Value to “0xff” and the number of iterations (the value of n in the above formula) to 1, WipeClean™ will perform a total of three passes, first writing all 0’s then again writing all 1’s. Then one more pass will be made that leaves a repeating “FF” pattern.

By default, WipeClean™ is set to erase data according to Department of Defense (DoD) specification M-5220. This setting is 3 passes and a final pattern of “0xF6”.

Set the number of passes to 0 for a single pass of the chosen pattern. This method is acceptable for

Logicube Omniclone Xi ™ User’s Manual 29