Logicube Omniclone Xi user manual WipeClean Settings, Wipeclean Target Step-by-Step

OMNIDIAGNOSTICS™

quickly wiping a drive where removal of sensitive information is not an issue.

WipeClean™ Settings

The following settings are used in configuring

WipeClean™ Target mode:

Passes – Determines how many passes of all 0’s and all 1’s are written to the drive. The default is 1 for compliance with DoD M-5220.

Value – Select the value to be written on the last pass. The options are 0xf6, 0x00, 0xff, and Random (DoD default). (The Random setting will fill the Target drive with a pseudo random pattern.)

Speed – The speed can be manually set from

UDMA 5 to PIO-SLOW.

NOTE: The unit will run at the fastest possible speed as long as a drive is attached to the Master position. This should not be an actual Master drive as a pattern will be written to part of the drive and it will be rendered unbootable.

If no drive is attached to the Master position the unit will still wipe the Target drives, but it will run at speeds ranging from 60 – 100 MB/min.

Wipeclean™ Target Step-by-Step

1.From anywhere in the menu system, press the Set button to enter the Settings menu.

2.Press the Cloning Mode icon that appears in the upper left-hand corner. A list of the available cloning modes appears.

3.Press the “WipeOut” icon, the Wipeclean Target™ settings screen will appear.

4.Touch the “Passes” icon to set the number of passes. Use the numeric keypad to enter the number of passes. Press OK when finished.

5.Touch the “Value” icon to scroll through the different patterns.

6.Touch the “Speed” icon to choose the best speed, if necessary.

NOTE: The unit will automatically adjust itself to the best speed for the attached drives.

7.Press the Start/Stop button twice.

30 Logicube Omniclone Xi ™ User’s Manual