Logicube Omniclone Xi user manual Using the USB Port

Page 48

USING THE USB PORT

1.Locate the USB icon in the system tray (typically at the bottom right of screen).

2.Click the icon once.

3.Wait for Windows to bring up a message that it is safe to remove the device. (Different versions of windows will behave slightly differently).

42	Logicube Omniclone Xi ™ User’s Manual

Image 48

Contents Logicube, Inc Chatsworth, CA Phone 818 700 Fax 818 700 Version Date 2/20/06Limitation of Liability and Warranty Information WarrantyLogicube Disclaimer Table of Contents Omnidiagnostics Logicube Omniclone Xi Software Update Loading Software Through the Parallel PortPage Introduction to the Logicube Omniclone IntroductionFeatures IntroductionUsing this guide System descriptionIntroduction Logicube Omniclone Introduction Applying power to the Logicube Omniclone Connecting Parallel IDE, EIDE, Udma DrivesGetting Started Fast Start Connecting Serial ATA Sata Drives Connecting other types of drivesPower and Reset buttons User interfaceTouch Screen Calibrating the Touch ScreenIndicator Lights ButtonsInstalling and Removing the Light Bar Buttons and InterfaceCloning Modes and Settings Time/Date SettingsMain Menu Screen About ScreenCloning DrivesClever Clone Mode Selective Partitions Mode OptionalClever Clone Step-by-Step Selective Partitions Step-by-Step CleverCopy Mirror Clone Mode Mirror Clone Step-by-StepMaster Manager Mode Optional Master Manager Step-by-StepDell Optiplex Computers and Master Manager Optional Preference Settings Verify SettingsVerify Speed Geometry CHS Translation ModesOn Error Optional General PreferencesIntroduction On Error Step-by-Step Set OptionSet Option Step-by-Step Last DriveLast Drive Step-by-Step Database/Barcode Option Password Setting a Password Step-by-StepRemoving a Password DatabaseOmniDiagnostics OmniDiagnostics FeaturesScan Target Mode Scan Target Mode Step-by-Step Repair Target ModeRepair Target Mode Step-by-Step WipeClean Target ModeWipeClean Settings Wipeclean Target Step-by-StepOmnidiagnostics System Contents Database/Barcode OptionCompact Flash CF Files Breakdown of Config.txt Database.csv Database Step-by-Step Database Settings Menu Creating a New Config List, Step-by-Step Barcode Scanner Settings Barcode ScannerDATABASE/BARCODE Option Using the USB Port Minimum requirementsHow to use under Windows for Master Drive Management Removing USB devicesUsing the USB Port Compact Flash CF Card Connecting the CF Drive to Windows via USB Connecting Through the Software Setup MenuCompact Flash CF Card User Replaceable Hardware Drive CablesRemoval and Installation of a Drive Station Proper Handling of Drive CablesDrive Stations Power Supply Removal and Installation of the Power SupplyLogicube Omniclone Xi Software Updating Procedures Loading Software Using the Compact FlashSoftware Loading Instructions Software Loading Instructions Host PC preparationLogicube Omniclone Xi Software Update Frequently Asked Questions and Answers FAQ’sFrequently Asked Questions and Answers Frequently Asked Questions and Answers Troubleshooting Guide Frequently Asked Questions and Answers Frequently Asked Questions and Answers Reference GlossaryCloning, Hard Drive ClusterReference DefragmentGeometry, Hard Drive LargeMaster Drive, Logicube Omniclone Master/Single Drive, IDE Parallel PortPartition RAM Disk SectorSlave Drive, IDE Target Drive, Logicube Omniclone Translation Mode, CHSWiping, Data Index FdiskIndex Reference Index