Tsunami MP.11 Installation and Management
Filter Operation Type
Passthru: Only the enabled Ethernet Protocols listed in the Filter Table pass through the bridge.
Block: the Bridge blocks enabled Ethernet Protocols listed in the Filter Table.
Static MAC Pair Filtering
The Static MAC Address Filter optimizes the performance of a wireless (and wired) network. The filter is an advanced feature that lets you limit the data traffic between two specific devices (or between groups of devices based upon MAC addresses) through the wireless interface of the MP.11.
For example, if you have a server on your network with which you do not want wireless clients to communicate, you can set up a Static MAC Filter to block traffic between these devices. However, note that this is an advanced filter and it may be easier to control wireless traffic through other filter options, such as Protocol Filtering.
Click Configure Î Filtering Î Static MAC Pair Filtering to optimize the performance of wireless and wired networks by denying unwanted data traffic from specific devices.
Wired MAC Address
Enter the MAC address of the device on the Ethernet network that you want to prevent from communicating with a device on the wireless network.
Wired Mask
Enter the appropriate bit mask to specify the range of MAC addresses to which this filter is to apply. To specify on the single MAC address you entered in the Wired MAC Address filter, enter FF:FF:FF:FF:FF:FF (all zeroes).
Wireless MAC Address
Enter the MAC address of the wireless device that you want to prevent from communicating with a device on the wired network.
Chapter 5. Web Interface | 48 |
CPN 63708 | Issue Date: 02/05/2003 |