Proxim CPN 63708 manual Setup and Configuration, Ethernet Link does not work

Tsunami MP.11 Installation and Management

Setup and Configuration

Ethernet Link does not work

First check the Ethernet LED;

▪Dim is “no media connected.”

▪Green and steady is 10 Base-T

▪Amber and steady is 100 Base-T

▪Blinking Green or Amber is traffic

Verify pass-through versus errors over cable.

Cannot use the Web Interface:

1.Open a command prompt window and enter ping <ip address MP.11> (for example ping 10.0.0.1). If the MP.11 does not respond, make sure that you have the correct IP address.

If the MP.11 responds, the Ethernet connection is working properly, continue with this procedure.

2.Ensure that you are using one of the following Web browsers:

ºMicrosoft Internet Explorer version 5.0 or later.

ºNetscape version 6.0 or later.

3.Ensure that you are not using a proxy server for the connection with your Web browser.

4.Ensure that you have not exceeded the maximum number of Web Interface or CLI sessions (with the CLI command show pelsessions).

5.Double-check the physical network connections. Use a well known unit to ensure the network connection is properly functioning.

6.Perform network infrastructure troubleshooting (check switches, routers, and so on).

Chapter 9. Troubleshooting	77
CPN 63708	Issue Date: 02/05/2003