Tsunami MP.11 Installation and Management
IMAGE FILE DOWNLOAD
In some cases, it may be necessary to upgrade the embedded software of the MP.11 by downloading an image file. To download an image file through the Web Interface:
1.Set up the TFTP server as described in “TFTP Server Setup” on page 64.
2.Access the MP.11 as described in “Web Interface Overview” on page 20.
3.Click: Commands Æ Download.
4.Fill in the following details:
Server IP Address <IP address TFTP server> File Name <image file name>
File Type Image
File Operation Download
5.Click OK to start the file transfer.
The MP.11 downloads the image file. The TFTP server program should show download activity after a few seconds. When the download is complete, the MP.11 is ready to start the embedded software.
CLI Image File Download
To download an image file:
1.Set up the TFTP server as described in “TFTP Server Setup” on page 64.
2.Access the MP.11 as described in “Command Line Interface Overview” on page 21.
3.Enter the following command:
download <IP address TFTP server> <image file name> image
The MP.11 downloads the image file. The TFTP server program should show download activity after a few seconds. When the download is complete and the system rebooted, the MP.11 is ready to start the embedded software.
Chapter 7. Procedures | 65 |
CPN 63708 | Issue Date: 02/05/2003 |