Figure 6.4-1 Parameter Locations, Descriptions, and Default Values
PARAMETER NAME/ | DESCRIPTION | SETTINGS (Default |
[MENU LOCATION] |
| Settings in BOLD) |
|
| |
Alarms Item 1 | Display of up to 16 active alarms. Scroll | Alarm Status Only |
{Status Only} | up or down to select individual alarms. |
|
[ALARMS] |
|
|
[告警] |
|
|
|
|
|
Battery Capacity | The total battery capacity in ampere- | 0Ah – 10,000 Ah, 0 Ah |
[SETUP/BATTERY/ | hours of the entire battery array. |
|
CAP] | Normally specified at 20 hour discharge |
|
[设置 / 电池 / 容量] | rate. |
|
|
| |
|
|
|
Battery Current | Battery current measured by the system | Battery Current Status |
{Status Only} | controller at the battery current shunt. | Only |
[STATUS/BATTERY/ |
|
|
PARAMETERS] |
|
|
[状态 / 电池 / 参数] |
|
|
|
|
|
Battery Float Voltage | One of three parameters that control the | |
[SETUP/BATTERY/ | dc output voltage. Set the Float Voltage |
|
VOLTAGE/FLOAT] | to the desired 25°C battery temperature |
|
[设置 / 电池 / 电压 / | per the battery manufacturers |
|
recommendations. |
| |
浮充] |
|
|
|
|
|
Battery Functional Test | Lowers the system voltage so a | ON, OFF |
[SETUP/BATTERY/TEST] | discharge test of the battery is |
|
[设置 / 电池 / 测试] | performed. ON – initiates a battery test. |
|
Off – stops a test in progress. |
| |
Battery Functional Test Result | Displays the results of the last battery | FAIL, PASS, |
[STATUS/BATTERY/TEST] | test. | INTERRUPTED, IN |
[状态 / 电池 / 测试] |
| PROCESS, NOT |
| PERFORMED | |
Battery Maximum Recharge | One of three parameters that control the | 0 – 500 A, 5 A |
Current | dc output voltage. If Battery Current |
|
[SETUP/BATTERY/CURRENT] | surpasses the Maximum Battery |
|
[设置 / 电池 / 电流] | Recharge Current, the dc output voltage |
|
will be reduced (the system limits the |
| |
| charging current to this programmable |
|
| value). |
|
Battery Mode Status | This will display the condition of the | Float, Equalizing or |
[STATUS/BATTERY/MODE] | battery. Float is normal operation. | Discharge. |
[状态 / 电池 / 模式] | Discharge means the rectifiers are not |
|
producing enough current and the |
| |
| batteries are discharging. Equalizing |
|
| means the voltage is above float voltage |
|
| to give the batteries an equalize charge. |
|
Magnum VS | Page 30 |