Page 87
Figure 7-13. Hot-Plug SCSI Hard Drives Connected to a RAID Controller Card
Removing a Hot-Plug Hard Drive
NOTICE: Not all operating systems support hot-plug drive installation. See the documentation supplied with your operating system.
1.Remove the bezel (see "Removing the Bezel" in "Troubleshooting Your System").
2.Take the hard drive offline and wait until the hard-drive indicator codes on the drive carrier signal that the drive can be removed safely (see Table 2-5).
If the drive has been online, the drive-status indicator will blink green two times a second as the drive is powered down. When all indicators are off, the drive is ready for removal.
See your operating system documentation for more information on taking the hard drive offline.
3.Open the hard-drive carrier handle to release the drive (see Figure 7-14).
Figure 7-14. Removing and Installing a Hot-Plug Hard-Drive
