Muratec F-100, F-150, F-120 manual Setting the number of rings, Setting ECM

1 Press /PROGRAM, J, 0, 3, ENTER. The LCD shows the current copy reduction rate:

Copy Reduc

Rate:Auto

If the setting you see is acceptable, skip to step 3.

Otherwise, proceed to step 2.

2	To change the setting, press or /PROGRAM repeatedly until your chosen
	reduction setting appears. In this example, we’ve chosen 75%.

Copy Reduc Rate: 75%

3 Press ENTER to save the setting. The LCD shows the current setting for the reduction margin:

Copy Reduc Rate: 75%

If the setting you see is acceptable, skip to step 5.

Otherwise, proceed to step 4.

4 To change the setting, use the numeric keypad to enter the reduction margin you want. If necessary, press or /PROGRAM to move the cursor if you need. In this example, we’ve chosen 00mm.

Copy Reduc Rate: 75%

5 Press ENTER to save the setting.

Setting the number of rings

You can set how many times your fax machine will ring before answering a call. You may choose one to nine rings.

1 Press /PROGRAM, J, 0, 6, ENTER. The LCD will show:

Set # Of Rings

If the setting you see is acceptable, skip to step 3.

Otherwise, proceed to step 2.

Beyond the basics

2 To change the setting, use the numeric keypad to enter the desired number of rings, from one to nine. Here, we’ve chosen four rings.

Set # Of Rings

Note: If you enter 0 (zero), the machine will beep brie¾y to warn you that it can’t accept that setting.

3 Press ENTER to save the setting.

Setting ECM

Ever hear static on the line during a phone call? It’s a real nuisance — but, worse, it may ruin your attempts to communicate via fax. This is because “line noise” can easily disrupt the flow of data from one fax machine to another.

That’s why your fax machine gives you the chance of operating in Error Correction Mode (ECM). When two fax machines communicate while running in ECM, the send- ing machine automatically checks the data, “block” by “block,” as it sends. If the receiving fax machine can’t verify the transmission, the first machine will re-send as necessary. (Essentially, the sending machine asks, “Did you ‘hear’ that seg- ment?” and the other machine answers either “Yeah; go on” or “No; try it again.”)

Note: While using ECM gives you a better chance of getting a fax document through a troublesome phone line, it also could slow down the transmission time — and increasingly so in proportion to how bad the phone line is. That’s why we let you turn ECM on or off as you require.

Note: Not all fax machines have ECM. If you’ve activated ECM and then transmit to a fax machine not currently using ECM, there will no change in the fax transmission from a usual, non-ECMtransmission.

1 Press /PROGRAM, J, 0, 8, ENTER. The LCD shows the current ECM setting:

ECM Mode: On

Program/Enter

If the setting you see is acceptable, skip to step 3.

Otherwise, proceed to step 2.

2	To change the setting, press or /PROGRAM once or twice until your chosen
	setting appears. In this example, we’ve chosen Off.

ECM Mode: Off

Program/Enter

3 Press ENTER to save the setting.

2.5