Muratec F-150, F-100, F-120 Dialing from the numeric keypad while using the PIN mask, 1Fax Number

Beyond the basics

Dialing from the numeric keypad while using the PIN mask

Note: If the PIN mask feature is off, you dial normally.

If you’ve specified Mode 1 — use “star” power

1 Enter the phone number, then press the * (“star”) key and enter the PIN. The PIN always goes last. For example, to dial 19725550911 with a PIN of “123456”, enter 19725550911*123456:

Press Start 19725550911*123456

2 Press START. The PIN disappears from the display, and your machine dials the desired phone number.

If you’ve specified Mode 2 — the machine guides you

1 Enter the phone number as usual.

Press Start 19725550911_

2 Press START. The LCD now shows:

Enter PIN Number

_

3 Use the numeric keypad to enter the PIN.

Enter PIN Number 123456_

4 Press START. Your machine will dial the number.

Performing batch transmission while using the PIN mask

Note: The following instructions presume you are familiar with how to set and use both your machine’s autodialer and its batch transmission feature. If you need to review, see pages 2.8–2.16 for more on the autodialer and/or pages 2.24–2.27 for more on batch transmission.

Note: If the PIN mask feature is off, you dial normally.

If you’ve specified Mode 1 or Mode 2

Important: Any autodialer number you use with batch transmission must include the PIN. (To review how to include this information in an autodialer number, review the Mode 1 instructions under “Autodialing while using the PIN mask,” page 2.50.)

Before sending a batch transmission to a desired number the first time, you must store the PIN within its batch box. Here’s how:

1 Perform the batch box setting until you’ve entered the batch box number. The LCD now asks for the fax number (here, we’re working with batch box 1):

1:Fax Number

_

2 Enter an autodialer number, or use the numeric keypad to enter the fax num- ber, to which the batch transmission should go.

Important: If you’re using an autodialer number, it must contain the PIN, as mentioned previously.

If you’re entering a number from the numeric keypad, enter the fax number, followed by the * (“star”) key and then the PIN.

3 Press ENTER to save the setting.

Note: If you press ENTER without entering the PIN, the fax machine beeps, indicates “No PIN Number” on the LCD and then returns you to step 2.

Now you can perform batch transmission to this box while the PIN mask is activated.

2.52