MACHINE'S BASIC SETTINGS
After installation is complete, you may want to set the machine's default settings. Refer to the next section if you would like to set or change values.
Altitude adjustment
The print quality is affected by atmospheric pressure, which is determined by the height of the machine above sea level. The following information will guide you on how to set your machine to the best print quality or best quality of print.
Before you set the altitude value, find the altitude where you are using the machine.
7.Press OK.
Setting the date and time
When you set the time and date, they are used in Delay fax and Delay Print, also they are printed on reports. If, however, they are not correct, you need to change it for correct time being.
If power to the machine is cut off, you need to reset the correct time and date once the power has been restored.
1.Press Machine Setup on the control panel.
2.Press Admin Setting.
3.When the login message appears, enter password with number keypad and press OK. (See "Setting the authentication password" on page 29.)
4.Press the General tab > Date & Time > Date & Time.
5.Select date and time using left/right arrows. Or touch the insert area and use the numeric keypad on the control panel.
6.Press OK.
To change the format of date and time, press Date Format and Time Format.
0
1 Normal
2 High 1
3 High 2
4 High 3
Changing the display language
To change the language that appears on the display, refer to the following steps.
1. | Press Machine Setup on the control panel. |
2. | Press Admin Setting. |
1.Enter your machine’s IP address as the URL in a browser and click Go to access the web site of your machine.
2.Log in to the SyncThru™ Web Service as an administrator. (See "Managing your machine from the website" on page 99.)
3.Click Settings > Machine Settings > System > Setup > Altitude Adj.
4.Select the appropriate altitude value.
5.Click Apply.
Setting the authentication password
To set your machine up or change the settings, you have to login. To change password, follow the next steps.
1.Press Machine Setup on the control panel.
2.Press Admin Setting.
3.When the login message appears, enter password. Touch the password input area, then the question marks appears, use the number keypad on the control panel to enter the password. Then, press OK. (Factory setting:1111)
4.Press the Setup tab > Authentication.
5.Press Change Admin. Password.
6.Enter old and new password, and then confirm the new password.
3. | When the login message appears, enter password with number keypad |
| and press OK. (See "Setting the authentication password" on page 29.) |
4. | Press the General tab. |
5. | Press the down arrow to switch the screen and press Language. |
6. | Select the desired language. |
7. | Press OK. |
Setting job timeout
When there is no input for a certain period of time, the machine exits the current location. You can set the amount of time the machine will wait.
1.Press Machine Setup on the control panel.
2.Press Admin Setting.
3.When the login message appears, enter password with number keypad and press OK. (See "Setting the authentication password" on page 29.)
4.Press the General tab.
5.Press Timers.
6.Select System Timeout.
• You can set the Held Job Timeout option to over one hour.
7.Select On.
8.Select a duration using left/right arrows.
9.Press OK.
Using energy saving feature
The machine provides energy saving features.
1.Press Machine Setup on the control panel.
2.Press Admin Setting.
3.When the login message appears, enter password with number keypad and press OK. (See "Setting the authentication password" on page 29.)
4.Press the General tab.
5.Press down arrow to switch the screen, press Power Saver.