•Off: Disables Job Build feature.
•On: Enables Job Build feature.
•Display Between Segments: After executing a segment, the job is paused with this screen. is displayed Then the user can select to keep copying or stop.
•Print: Prints the sample page(s) of a segment to confirm the contents.
•Delete: Deletes a segment.
•Delete All: Deletes all segments.
•Print All: Prints all segments.
•Add Segment: Adds a new segment.
•Cancel: Removes all segments in the list, and cancels the job.
5.Press Add Segment.
6.Place originals, face up, in the DADF, or you can use the scanner glass with a single original document face down.
7.Press Start on the control panel. Then the machine starts scanning.
8.Repeat step 5 to step 7.
As long as the hard drive capacity of your device remains, you can add segments without any restriction.
9.After adding segments, press Print All.
ID card copying
The machine prints one side of the original on the upper half of the paper and the other side on the lower half without reducing the size of the original. This feature is helpful for copying a
This copy feature is available only when you place originals on the scanner glass.
The original must be placed on the scanner glass to use this feature.
1.Place the front side of an original facing down on the scanner glass where arrows indicate as shown, and close the scanner lid.
2.Press Copy from the Main screen.
3.Select the tray in Paper Supply.
4.Press the Advanced tab > ID Copy.
5.Press Start on the control panel.
Then the machine starts scanning the front side.
6.Turn the original over and place it on the scanner glass, where arrows indicate as shown. Then, close the scanner lid.
7.Press Start on the control panel to begin copying.
• If the original is larger than the printable area, some portions may not be printed.
•If this option is grayed out, select the Duplex option to 1
Copying ID with the manual ID copy option
If you want to copy several ID cards on a paper, or adjust the copying position of the page, follow the next steps.
Next steps are the procedure when you copy two people's driver's license cards (100mm X 80mm) in one page.
1Press Machine Setup on the control panel.
2Select Admin Setting. When the login message pops up, then enter password and press OK.
3Press the Setup tab > Copy Setup > Manual ID Copy Setup.
4Press the number from the template list table.
5Press Edit Template.
6Selec the appropriate option values and press OK.
•Template Name: Enter the template name.
•Scan Position: Select the position for scanning. You should select the largest scanning position out of the originals.
LEFT, TOP :
•Number of Images: Select how many images are on a page. (select number 4.)