Important Note on Initial Operation of the Receiver on a UFO®micro System
It is absolutely essential to carry out the following before and while registering receivers on the EXU 544 UFO®micro
-Connect the receiver to the TV set, but do not yet connect it to the UFO®micro ESU 32 outlet!
-You must first check the following settings on the “LNB Configuration” menu and change them as necessary:
1.Press the button to switch to the main menu
2.Press to get to the installation menu and confirm your entry by pressing
3.Press to get to the LNB configuration menu and confirm your entry by pressing
4.Press to select the “ASTRA” satellite and confirm your entry by pressing
5.Press to select “Tuner input” and press to change the selection to "#1 & #2“
6.Press to quit the
You must run through steps 4-6 for each satellite received!
7.Press three times to get back to the start screen
8.Interconnect the “LNB1 LOOP OUT” tuner output and the “LNB2 IN” tuner input by a coaxial cable (F standard connector).
-Now carry out a UFO®micro reset on the receiver, as described below:
1.Press the button to switch to the main menu
2.Press to get to the installation menu and confirm your entry by pressing
3.Press to get to the DiSEqC[UFO]
4.Press to select the UFO option
5.On the UFO menu press to select “UFO®micro”
6.Press and change your selection to RESET by pressing Confirm your selection by pressing
7.Press to quit the UFO menu (press to save your changes)
8.Press three times to get back to the starting point
-Press to switch the receiver to standby mode
-Now you can connect the receiver to the ESU 32 outlet
-Press to switch the receiver on
-The registration is then performed automatically – the screen briefly shows: “UFO®micro active”
-Now perform a UFO®micro reset as described above (items
10