Kathrein UFD 580S manual Tone Burst, DiSEqC Repeat, UFO mini, Remote Frequency

Installation Menu

Tone Burst

Here the 22 kHz signal can be set as follows:

Switching states for setting:

22 kHz Signal —>		High/Low
and
Tone Burst	—>	Pos. A/B:
Low	22 kHz	Off
High	22 kHz	On
Pos. 1	Tone Burst	0
Pos. 2	Tone Burst	1

Switching states for setting:

22 kHz Signal		—> Pos. A/B
and
Tone Burst		—> Opt. A/B
Pos	Tone Burst		22 kHz
1		0	Off
2		0	On
3		1	Off
4		1	On

Switching states for setting:

22 kHz Signal —>		Pos. A/B
and
Tone Burst	—>	High/Low
Low	Tone Burst	0
High	Tone Burst	1
Pos. 1	22 kHz	Off
Pos. 2	22 kHz	On

DiSEqC™

If the receiver is connected to a DiSEqC™ switching matrix, set the menu option to “On”.

The switching criteria and the input assignment of the DiSEqC™ switching matrices must be observed. You should therefore follow the description of the switching matrices or contact the engineer who installed the reception system.

DiSEqC™ Repeat

If the receiver is operated in a reception system with two or more

DiSEqC™ switching matrices connected in series (cascaded), the

DiSEqC™ command must be repeated.

In this case, set the “DiSEqC™ Repeat” menu option to 1 or 2.

Default setting: “Off”

UFO® mini

In a subscriber-controlled processing system, the input frequency of the receiver is a fixed setting. The subscriber-controlled processing system transmits the signals at this frequency. The reception parameters for programme selection are communicated to the reception system by a DiSEqC™ command and set.

The setting that has to be selected depends on the design of the subscriber-controlled processing system.

The setting is made according to the installation instructions for the subscriber-controlled processing system.

Remote Frequency

If you have set the UFO®mini menu option to “ON”, use this menu option to make the setting from the transmission frequency.

The transmission frequency to be set is specified in the installation manual for the subscriber-controlled processing system.

You should therefore be sure to follow the instructions given in the installation manual for the subscriber-controlled processing system.

81