Installation Menu
UFO®micro
Factory Set
Logging on to UFOmicro®
Important: The receiver must not be connected to the antenna socket outlet prior to logging on!
The setting for this menu option is also designed for operation of the receiver in a processing system.
The return path of the coaxial cable is used for control and communication between the receiver and the Kathrein UFO®micro system. If the receiver is operated in a UFO®micro reception system, the “UFO®micro” menu option must be set to “On”.
The reception system then assigns the receiver a special address upon installation, so that it will recognise the control commands sent by the receiver to the reception system for signal selection.
In this operating mode, a remote frequency does not need to be set, as it is specified by the UFO®micro system with the addressing.
If the receiver is being used in a UFO®micro reception system for the first time, the address previously assigned must be deleted. This is done under the “UFO®micro” menu option by selecting “Reset” with
the buttons and confirming with .
The receiver is then assigned the original factory setting. It then needs to be set to “On” again. The receiver receives its new address from the new system.
“Reset” does not delete the pre-programming.
Default setting: “Off”.
Under this menu item, you can reset all the settings to their factory defaults by pressing .
The factory settings do not necessarily correspond to the settings required for your specific system.
You may need to
Note down the settings on the service page provided at the end of this manual!
Procedure (see page 10)
82