Kathrein UFD 580S manual Installation Menu, LNB Configuration, Oscillator Frequency L.O

Installation Menu

You should not change the following settings without a good reason, as they are factory settings or operating settings that are tailored to your reception system.

New settings are only required if the reception system is changed or expanded.

Select the “Installation” menu with the  button, the  buttons in the main menu and . If a password has been stored, you must enter it. Use the  buttons to select the further items.

LNB Configuration

Pay attention to the bar at the bottom of the on-screen display! It provides guidance on what to do next.

Oscillator Frequency L.O.

The first submenu is the “LNB Configuration”. Press  to open it. You should not normally make any changes in this submenu.

Before making any changes, however, you should make a note of the settings in the form provided at the end of this manual. Your receiver is preset at the factory to the satellites of the ASTRA and HOTBIRD systems.

The other basic settings are shown in the screenshot above.

Satellite reception systems consist of a parabolic antenna attached to the actual reception system (LNB - Low Noise Blockconverter or LNC - Low Noise Converter), which converts the RF signal from the satellite into a lower frequency that can be processed by a satellite receiver.

The satellite transmission frequencies are located in the following ranges:

10.7-11.7 GHz	Low band
11.7-12.75 GHz	High band

72