Kathrein UFD 580S manual Adding/Removing Satellites, Satellite Setup

Adding/Removing Satellites

Satellite Setup

Pay attention to the bar at the bottom of the on-screen display! It provides guidance on what to do next.

Note:

In two-cable systems the tuner input must be set to "#1 & #2".

The DiSEqC™ settings must match the installed reception system.

In single-cable reception select the tuner input used. Set Loop when the output of tuner #1 is connected to tuner input #2 or vice versa.

New satellites can of course also be added to the LNB configuration. To do this, you must know the orbit position you need to aim at. The “Antenna Setup” item on the installation menu can be used as an aid in aligning the antenna.

To access the “LNB Configuration”, press  for the main menu, use the  buttons to select the "Installation“ submenu and confirm with

(also entering your password, if activated). Press  to select “LNB Configuration”, and you can enter or select a new satellite.

Note that your system must be configured accordingly!

In the next step, use the  buttons to move to the “User1” entry

for example. After pressing the  or  button, you are asked if you want to add the satellite.

Confirm with .

The following message appears:

70