Kathrein UFD 580S manual Setting Index Marks Skip Points, Index marks at the end of a recording

Hard Disk Recorder

Setting Index Marks (Skip Points)

	During playback and with the control console displayed (opened with
	the  or  button), index marks (skip points) can be set and can
	then be displayed above the time bar by pressing the  button. This
	function is used to skip specific parts of a recording (from the
	beginning marker to the next end marker) during the next playback, so
	as to cut adverts out of films for example.
Note:	You cannot set index marks as long as the small control console pop-
	up (opened with the  button) is on display. Also, you cannot set
	index marks at the end of a recording!
	Further control console functions can be displayed during playback.
	To access them, first press the  or  button (to open the control
	console), then the  button.
	If there is a block of adverts at the end of your recording which you
	want to remove, you must use the “Split take” function. The split
	portions of the recording will be saved to the hard disk separately. You
	can then delete the second part of the split (the block of adverts) from
	the hard disk in the same way as you would delete any other
	recording. To do this, place the time bar at the start of the last block of
	adverts and execute the split by navigating to the “Split take”
	command using the  buttons and confirming with .

•	Lock	Yes/No	Parental control
			On/Off
			Playback is locked
			(protected by password)
•	Clear skip points		Clears all index marks
			Recording is split
			at the current position
			(e.g. when recording

two programmes one after the other)

The individual functions can be set with the arrow buttons.

51