GTO RB923 rev installation manual Installing The Second Unit, Step D1, StepD2

Installing The Second Unit

The diagram below shows a dual gate, pull-to-open (gate opens into the property) installation on iron gates.

If you are installing a Push-to-Open (gate opens out) system see Push-to-Open Installation starting on page 31.

Receiver

Control Box with Battery

120 Volt Indoor

Transformer

(Surge Protector,

not supplied)

Run up to 1000' of low voltage wire to control box from transformer. (wire not included)

Post Bracket Assembly
Gate Bracket
GTO/PRO 2000 – First Operator		GTO/PRO 2200 – Second Operator
Power Cable	Closed Position Positive Stop Plate

PVC conduit (not included) to protect wire from lawnmowers and weedeaters.

The open position stop for
the second gate is installed	Gate Hinge	Ground Stop (under gate)	Gate Hinge
the same as the first gate.
See instructions on page 16.
The Closed position stops
on a dual gate system		Closed Position
require a ground stop for		Stop Plates
the second gate (first to
close) to be installed as		Not to exceed 110°	Not to exceed 110°
follows:
Step D1:		Wood, metal, or concrete
		post set in concrete.
	Open Position Stop		Open Position Stop
Attach the closed position
stop plate vertically to the
inside bottom of the gate
that will receive the
second operator (for push-
to-open, install plate on
outside of gate). In this		Closed Position Stop Plate mounted
illustration this is the gate
		on second gate (first gate to close).
that will close first.
			SIDE VIEW

	Closed position stop plate
StepD2:	Low profile ground stop
Install a closed position ground stop in driveway securely	in middle of driveway
	FRONT VIEW
into ground directly below the gate. The positive stop
plate installed in Step D1 should rest against the ground
stop in the closed position. For added security, install a
GTO Automatic Gate Lock (see Accessory Catalog).

38