Maxi-Cosi THE SAFE WORLD OF I 14English, Or Maxi-Cosi EasyBase, Removing the Maxi-Cosi CabrioFix

0114_GBA_cabriofix_I_BW 15-03-2006 12:30 Pagina 14

1213

14

•Place the shoulder section of the seat belt around the Maxi-Cosi CabrioFix and slide it into the blue belt hook on the back (12). The retaining hook holds the seat belt in place (13). Insert the tongue section into the buckle (14,3).

•Make sure the seat belt is not twisted. Tighten it as much as possible.

•Check again to make sure the seat belt is threaded through all three blue belt hooks.

	4.2 Installing and removing the Maxi-Cosi CabrioFix when used with the Maxi-Cosi EasyFix
GB	or Maxi-Cosi EasyBase

The “click-and-go” installation on the Maxi-Cosi EasyFix and on the Maxi-Cosi EasyBase reduces the likelihood of incorrect installation in the car.

The Maxi-Cosi EasyFix or Maxi-Cosi EasyBase should be installed first of all.

WARNING: To install or to remove the Maxi-Cosi EasyFix and Maxi-Cosi EasyBase see the instruction manual of the Maxi-Cosi EasyFix and Maxi-Cosi EasyBase. The safety of your child is only guaranteed if the seat is used correctly. It is therefore important that you take the time to read these instructions through carefully. However, if you do not have the above mentioned instructions, contact our service point in your country or download the necessary information from our internet site: www.maxi-cosi.com.

A. Installing the Maxi-Cosi CabrioFix

15• Position the Maxi-Cosi CabrioFix facing backwards (rearward-facing) on the Maxi-Cosi EasyFix / Maxi-Cosi EasyBase (15). The carrying handle should be in the upright position.

16• Click the Maxi-Cosi CabrioFix with its 2 attachment rods onto the Maxi-Cosi EasyFix / Maxi-Cosi EasyBase (16).

17• NOTE! A clear click should be audible and the indicators on the side of the base should now be completely on green (17).

•NOTE! Under no circumstances should this product be used if the indicator remains on red. Carry out the above actions again. In case of doubt or if you have any questions, contact the supplier.

•Check that the Maxi-Cosi CabrioFix has been installed correctly by pulling on it.

B. Removing the Maxi-Cosi CabrioFix

18• Unlock the Maxi-Cosi CabrioFix by pulling the release lever upwards and at the same time forwards (18).

19• The Maxi-Cosi CabrioFix can now be taken out of the Maxi-Cosi EasyFix / Maxi-Cosi EasyBase (19).

14English