VistaQuest N7227V5 Press 74 LOW BAT Restore Report Code, Press 94 Download Phone Number

Press ✱74 LOW BAT RESTORE REPORT CODE

This is sent when a system low battery condition is restored to normal.

Press ✱75 RF XMTR. LOW BATTERY RESTORE CODE

This is sent when a transmitter that previously sent in a low battery message has sent a message indicating it no longer has a low battery condition.

Press ✱92 NUMBER OF REPORTS IN ARMED PERIOD

This option can be used to limit the number of messages (alarm & alarm restore reports) sent to the central station in an armed period. “0” limits reports to a total of 10; “1” allows an unlimited number of reports.

Press ✱94 DOWNLOAD PHONE NUMBER

Enter up to 12 digits;

0–9, # + 11 for “✱ ”, # + 12 for “#”, # + 13 for a pause. Do not fill unused spaces. End field by entering “✱”. To clear entries, press ✱94✱.

Press ✱95 RING DETECTION COUNT FOR DOWNLOADING

Refer to the chart below and program this field accordingly.

Voice	Answering
Module	Machine	Downloading	Field ✱95 Programming
Yes	No	No	Set for value other than “0” (1–14).
			This will enable the control panel to
			answer the phone call. Otherwise, it
			will not be possible to access the
			Module.
Yes	Yes	No	Set for a value higher than the
			number of rings for which the
			answering machine is set. Example:
			if machine is set for 4 rings, use value
			5 or higher. This is recommended so
			that the Phone module can still be
			accessed if the answering machine is
			turned off and does not answer the
			phone call.
Yes	No	Yes	Set for value other than “0” (1–14).
Yes	Yes	Yes	“15” to bypass answering machine.
No	No	No	Enter “0”
No	Yes	No	Enter “0”
No	No	Yes	Enter 1–14
No	Yes	Yes	Enter 15. See Imortant Note below.

Important Note: If “15” is entered in field✱95 to bypass an answering machine, and a 4285 Phone Module is included in the installation, you should note the following: When calling in from an off-premises phone (to receive a status report or execute a command), the user should make the initial call, allow 1 to 3 rings only, and hang up. Then call in again – the Phone Module will now seize the line, and 2 long tones will heard, followed by the usual voice prompt for the 2-digit phone access code. If this procedure is not followed, Phone Module operation will not be possible.

✱96 INITIALIZE DOWNLOAD ID AND SUBSCRIBER ACCT. No. FOR DOWNLOADING (No data entry required)

This completes the communication programming.

Exit the programming mode by keying ✱99.

Refer to the TESTING THE SYSTEM section to check system operation.

– 70 –