•The " EXIT ALARM " display, etc. will also result if an alarm from an exit or interior zone occurs within two minutes after the end of an exit delay.
In any of the previous cases, use a second OFF sequence (code plus OFF key) to clear the display.
Trouble Conditions (See Troubleshooting Guide also)
General Information
The word "CHECK" on the keypad's display, accompanied by a rapid "beeping" at the keypad, indicates that there is a trouble condition in the system. The audible warning sound can be silenced by pressing any key. Instruct users to call for service immediately upon seeing any of the following messages.
"Check" and | • | A display of " CHECK " and one or more zone numbers indicates that a |
"Battery" |
| problem exists with the displayed zone(s) and requires attention. |
Displays | • | A display of “CHECK ” and 09 indicates that communication between control |
| ||
|
| and a zone expander or wireless receiver is interrupted. Check the wiring |
|
| and DIP switch settings on the units. |
| • If there are wireless sensors in the system, the CHECK condition may | |
|
| also be caused by some change in the environment that prevents the |
|
| receiver from receiving signals from a particular sensor. |
| • A display of "BAT" | |
|
| keypads) with no zone number indicates that the system's main standby |
|
| battery is weak. |
| • | A display of "BAT" |
|
| with a zone number and a once per minute "beeping" at the keypad |
|
| indicates that a low battery condition exists in the wireless sensor displayed |
|
| (zone "00" indicates a wireless keypad). If the battery is not replaced within |
|
| 30 days, a CHECK display may occur. |
|
| Note: Some wireless sensors contain a |
|
| which requires replacement of the entire unit at the end of battery life |
|
| (e.g., Nos. 5802, 5802CP). |
Power Failure | • | If there is no keypad display at all, and the POWER indicator (if |
|
| present) is not lit, operating power for the system has stopped and the |
|
| system is inoperative. |
|
| Note: The control panel will power up in its previous state (armed or |
|
| disarmed) after a complete power failure, but will not retain any |
|
| memory of bypasses. |
| • | If the message " AC LOSS " (Alpha keypads) or "NO AC " |
|
| keypads) is displayed, and the POWER indicator (if present) is off, the |
|
| keypad is operating on battery power only. |
Note: There is a random delay up to 48 minutes before the system will report an AC failure to the central station. The keypad response is about 6 seconds. The restore report has a random delay of up to 12 minutes (if the AC failure report was sent).
• If the battery standby capacity is used up during a prolonged AC power outage, the control's auxiliary power will shut down to minimize deep discharge of the battery.
Other Displays (Fixed Word displays are in parentheses)
Modem Comm (CC ) The system is in communication with the central station for change of function or status verification.
Comm. Failure (FC) A communication failure has occurred.
Open Circuit (OC ) The keypad is not receiving signals from the control and sees an open circuit.
Long Rng Trbl (bF )
– 76 –