VistaQuest N7227V5 installation instructions Checking the Operation of the 4285 Phone module

Checking the Operation of the 4285 Phone module

To Check Phone module Operation From an On-Premises Phone

1.Pick up phone and enter the programmed 2-digit phone code (entered in field ✱ 26, VOICE (PHONE) MODULE ACCESS CODE). Annunciation of a system status report should automatically start. See the User’s Guide accompanying the Phone module for detailed information regarding the nature of the status report, if necessary.

2.During any pause in the status report, or immediately following it, key the following via the keypad on the phone:

INSTALLER Code (4111), then press key 1 (OFF).

3.A ”beep” should be heard on the phone and from a wired keypad, and the words DISARMED...READY TO ARM or DISARMED...NOT READY TO ARM * should be heard, indicating that the command was entered successfully.

*DISARMED...NOT READY TO ARM would indicate an open zone.

4.Hang up the phone.

To Check Phone module Operation From an Off-Premises Phone:

1.Have someone dial the premises phone number, using a Touch-tone phone .

•If the phone system does not include an answering machine, 2 long tones will be heard in the caller’s phone, followed by a voice prompt "HELLO, ENTER PHONE CODE NOW" . The caller should then enter the programmed 2-digit phone code (entered in field ✱26, VOICE (PHONE)

MODULE ACCESS CODE).

•If the premises phone system includes an answering machine, the 2- digit phone code should be entered during a pause at the beginning of, or during, the outgoing answering machine message.

2.When the 2-digit phone code is entered, the caller will hear a voice prompt asking for entry of the 4-digit system code (" ENTER SYSTEM CODE NOW ").

3.The caller should then enter the INSTALLER code (4111). As a safety feature, there is a 3-try limit in which to enter each code (phone code and system code), after which time the call-in will be aborted. Also, if no keys are pressed for a period of 20 seconds, the call-in will be aborted.

4.Annunciation of a system status report will start if both codes were entered correctly.

5During any pause in the status report, or immediately following it, the caller should key the following via the keypad on the phone:

INSTALLER Code (4111), then 1 (OFF).

6.A ”beep” should be heard (and from a wired keypad on the premises), and the words DISARMED...READY TO ARM or DISARMED...NOT READY TO ARM* should be heard on the caller’s phone, indicating that the command was entered successfully.

*DISARMED...NOT READY TO ARM would indicate an open zone.

7.At this point, the caller can hang up the phone.

8.Verify with the caller that there was successful access to the system and that the appropriate annunciations were heard over the phone.

– 48 –