6.Use the joystick to select an area title display position, and then press the MON (ESC) button. This registers the area title display position and returns to the area title (NESW) setting menu.
FLOOR 1
N
Note: The area title is always displayed under the camera ID. If you specify different display position settings for the camera ID and the area title ID, the area title ID display position setting is used for both.
(2) When ON (USER) is selected
After selecting ON (USER), you can use the area title (USER) setting menu to configure detailed settings. You can use the following procedure to configure direction settings, and to input text associated with a particular direction indicator.
1.Move the cursor to 1, and then press the CAM (SET) button.
This will display the position setting menu. An asterisk
(*)to the right of an area title number indicates that it already has an area title assigned to it.
If the there is already text associated with the direction you selected, it will appear under the cross mark (+). If there is no text associated with the direction, only the cross mark (+) will be displayed.
**AREA TITLE(USER)**
1* | NORTH |
2
3
4
5
6
7
8
RET TOP RESET
2.Adjust the camera orientation (pan and tilt), zoom, and focus.
Perform steps 1 through 4 under “(1) When ON (NESW) is selected” on page 34.
**DIRECTION(USER) 1**
PAN/TILT | →PUSH SET |
ZOOM/FOCUS | →PUSH SET |
+
NORTH
RET TOP DEL
3.Move the joystick to the right to align the cursor with the title display, and press the CAM (SET) button. This will display the area title setting menu.
In the example screen shown in step 1, NORTH O is the title name of area title number 1.
4.Input an area title.
The text input procedure is the same as that for camera ID input.
See steps 3 through 5 under “(1) Camera ID (CAMERA ID)” on page 22 for information about inputting the text for the area title and specifying its position on the display.
AREA TITLE 1 0123456789 ABCDEFGHIJKLM NOPQRSTUVWXYZ ().,'":;&#!?=
SPACE
----POSI RET RESET
................
FLOOR 1
NORTH
5.Repeat steps 1 through 4 for the other area numbers, if you want.
(13) Tilt Angle Setting (TILT ANGLE)
Selecting 5° for the TILT ANGLE setting allows tilting past horizontal, in the range of
1.Move the cursor to TILT ANGLE, and then tilt the joystick left or right to toggle the setting between 0° and 5°.
Notes:
•Zooming to WIDE while 5° is selected for the TILT angle setting will cause the upper half of the picture to become hidden.
•With certain subjects, AGC (gain control) can cause the image to become white.
(14) Cleaning Settings (CLEANING)
This camera uses a "slip ring" for transmission of electrical power and signals. A dirty slip ring can cause deterioration of picture quality and generation of noise.
The cleaning function performs cleaning approximately once a week to keep the slip ring clean.
1.Move the cursor to CLEANING, and then tilt the joystick left or right to toggle it on and off.
The text CLEANING appears in the center of the screen while the cleaning process is being performed.
Note: Select OFF for CLEANING before performing an upload or download data with a system device. This protects against the download or upload failure due to start up of the cleaning process.