PASSWORD SETTINGS
■Password Lock Settings
Set the password lock on the setup menu.
●Turning Password Lock On and Off
The password lock function can be used to allow only authorized personnel to change camera settings. A password must be input in order to turn password lock on or off.
ON : Prohibits changing any settings except for the password lock function.
Selecting this setting limits camera configuration changes to authorized personnel.
OFF : Settings on all menus can be changed.
If you are using a VCR for recording, turn off recording before inputting the password. Inputting the password while the picture is being recorded by a VCR will cause the password to be recorded with the picture.
1.Display the setup menu (page 21), move the cursor to PASSWORD LOCK (ON or OFF), and then press the CAM (SET) button.
MODEL
CAMERA 
PAN/TILT 
ALARM 
SPECIAL 
COMMUNICATION 
SCENE SELECT 
LANGUAGE 
→QUICK SETUP
PASSWORD LOCK OFF 
This will display the password input menu.
2.To set the password for the first time, enter the factory default password "123" and then press the CAM (SET) button.
Note: You must use this procedure. The password Lock ON/OFF does not switch.
3.Input a
** PASSWORD? **
0 1 2 3 4 5 6 7 8 9
. . .
OK RESET
NEW PASSWORD
RET TOP
for each digit.
The ↑ pointer will move to the right each time you input a digit. After you input all three digits, move the cursor to OK.
If you make a mistake during input, move the cursor to RESET, press the CAM (SET) button, and then re- input the entire password.
Note: The factory default password is 123.
4.Press the CAM (SET) button.
This returns to the setup menu and toggles PASSWORD LOCK on or off.
The password input screen will reappear if you press the CAM (SET) button after inputting the wrong password. If this happens, perform steps 2 and 3 again.
●Changing the Password
After turning on password lock, it is recommended that you use the following procedure to change the factory default password to a different one. Also, make sure you keep a separate record of your password so you do not forget it.
If you are using a VCR for recording, turn off recording before inputting the password. Inputting the password while the picture is being recorded by a VCR will cause the password to be recorded with the picture.
1.Display the setup menu (page 21), move the cursor to PASSWORD LOCK (ON or OFF), and then press the CAM (SET) button.
This will display the password input menu.
MODEL
CAMERA 
PAN/TILT 
ALARM 
SPECIAL 
COMMUNICATION 
SCENE SELECT 
LANGUAGE 
→QUICK SETUP
PASSWORD LOCK OFF 
2.Input the current
(SET) button for each digit.
The ↑ pointer will move to the right each time you input a digit. After you input all three digits, move the cursor to OK.
If you make a mistake during input, move the cursor to RESET, press the CAM (SET) button, and then re- input the entire password.
** PASSWORD? **
0 1 2 3 4 5 6 7 8 9
. . .
OK RESET
NEW PASSWORD
RET TOP