4.If needed, enter the safety code by pressing the following number keys in sequence: 1, 2, 3, 4.
The running belt starts automatically after a
5.Press the SPEED up arrow key until the display shows a speed of 3 mph (5 kph).
CAUTION: If you hear any chafing or the running belt appears to be getting damaged, stop the running belt immediately by pressing the red STOP button.
Contact Precor Customer Support.
6.Walk around to the rear of the unit and observe the belt for a few minutes. The belt should be centered on the running belt. If the belt drifts off center, you must make adjustments. Refer to Adjusting the Running Belt.
Important: Failure to align the belt may cause the belt to tear or fray, which is not covered by the Precor Limited Warranty.
7.To stop the running belt, press the red STOP button.
8.Turn the treadmill Off.
Adjusting the Running Belt
If you are unsure about adjusting the running belt, call Precor Customer Support. Refer to Obtaining Service.
CAUTION: For your safety, use the power switch to turn Off the treadmill before making any adjustments. Do not adjust the running belt when someone is standing on the unit.
1.Locate the right belt adjustment bolt in the rear end cap of the treadmill. Refer to Diagram 11.
Diagram 11: Location of the adjustment bolt
To determine left and right, stand at the rear of the treadmill and face the display. Make all belt adjustments on the right rear corner bolt using the hex key provided.
Owner’s Manual: Maintenance | 60 |